Gold Member Since 2016

NINGBO XIEDUAN PRECISION MACHINERY INTERNATIONAL TRADE CO., LTD.

C Frame Hydraulic Press, H Frame Hydraulic Press, Forging Hydraulic Press manufacturer / supplier in China, offering (160ton-600ton) H Frame Double Crankstransfer Power Press, 400 Ton Progressive Press Stamping Line, H Frame Power Press Stamping Line, 110ton-600ton Gantry Type Single Crank Power Press and so on.

(/ )

Supplier Homepage Company Show Service Support Process of installation module on press

Service Support

Process of installation module on press [Aug 10,2016]
Process of installation module on press
Process of installation module on press

1. First, before installation, please make sure the die cutting edge is sharp, lower die cutting edge has no gap, force plug has no defect. If any defect, please grind incision.

 2. Please put one piece of Si between up and lower die before matching dies in order to prevent incision damage.

 3. Grind off the burr of top and bottom with whetstone, clear trash with list before installation module. Or it will cause poor burr on products.

 4. Compress up-die after adjusting slider stroke to suitable position. Compress lower-die joint closely with slide until force plug is 3~4mm enter into lower die, then lightly compress the lower die board bolts. Next, adjust slide upwards, take out the middle Si piece. Loose lower die board bolts, adjust slide board bolts downwards. Force plug must enter 3-4mm into lower die when new module press, otherwise, force plug will be collapsed or lower die will be broken.

 5. Upload slide to up dead point, adjust bolts to suitable loose, then turn over several times, observe if module and press structure operate regularly. If no, begin running.

Xieduan Products Contents :
C frame Crank Press (15ton-315ton)
Straight Side Press (160ton-1200ton)
Coil Feeders
 
Xieduan Advantages:
Professional training staff
One-stop service
Comprehensive maintenance system
Keep a full range of spare parts on hand in order to minimize any downtime